INTRODUCTION

This manual provides all the necessary information regarding the correct use of the machine and its maintenance, as well as safety standards to take into account to ensure safe use.

The information in this manual should be preserved andrespected since the manufacturer is not liable for damage caused to persons and objects due to improper installation or use.

The manufacturer reserves the right to modify the instruction manual without the obligation to revise previous editions.

Cleaning and user maintenance shall not be made by children without supervision.

This device can be used by children over eight years old, persons with reduced physical, sensory or mental capabilities or lacking experience and knowledge unless they are supervised or were given instructions regarding the use of the machine, in a safe way and understanding the risks involved.

Children should not play with the device.
The device should not be installed in an area where water jets can be used.

If the power cord is damaged, it should be substituted byFUTURETE, by its after-sales service or a similarly qualified person in order to avoid any danger.

Always connect the machine to an earthing system.

Remove the plug from the socket to disconnect the device before performing any cleaning and maintenance (only for machines that have a plug).

The user must comply with the safety standards in force in the country of installation. The user should avoid operating the machine barefooted or with wet feet and should not touch the device’s hot surfaces or the power cord, at risk of serious injuries.

The device should not be placed on extremely hot surfaces or near flammable materials, in order to avoid damaging the housing.

SPECIFICATIONS

Table 1 - Properties of machines with a > 8 L Boiler.

Table 5 - Common properties of all machines.

All Equipments

Boiler Nominal Pressure
Pump Nominal Pressure
Ambient Temperature [min - max] Average Sound pressure Level-A

0.05 – 0.2 [MPa] 0.8 – 1 [MPa]
5 – 50 [oC]
84dB ± 3dB

FUTURETE coffee machines operate according to the variables described in the previous tables and it is not FUTURETE’s responsibility the damage caused by the non-compliance of these numbers.

ACCESSORIES

The FUTURETE coffee machine is supplied with the following accessories:

• Filter holder for two cups;

• Filter holder for one cup;

• Blind filter;

• 3/8-3/8 stainless steel connector for water inlet;

• 1500mm drain hose.

4

INSTALLATION

When installing the FUTURETE coffee machine verify if the location gathers the necessary conditions for its correct use. Never install it in places with water jets.

Choose a levelled support surface, with easy electrical supply, running or bottled water access and sewage.

IMPORTANT: the access to running water must be earthed in order to guarantee differential protection, so that there is no electrocution hazard for the user. The device is provided with fixed electrical installation, therefore it is strictly forbidden to use wall sockets (only for 3 group models), or multiple sockets and extensions (for 1 group, 2 group and 3 group models).

The installation of the equipment must be settled in a place where its maintenance is always made by trained personnel, so that they can keep the machine under surveillance.

It is important that the rated residual operating current not exceed 30 mA, given that it has a leakage current superior to 10mA.

When performing all the previously described procedures, turn the main switch to position 1, wait for the automatic filling of the boiler to be complete. Turn the switch to position 2 so that the red signal lights up and the resistance is activated. Wait until the the right pointer of the manometer reaches 1 bar.

At this moment, the equipment can be used, but always verify if the coffee grind used is adequate.

EN

5

The device has 1 or 2 steam wands that should be opened before being used, to clean eventual residue of a previous use.

The connection of the device should be performed according to the following scheme:

Figure 1 - Single-phase and multiphase machine connection scheme.

As shown in the above picture, for single-phase machines (230V 1N ~), the brown wire of the power cord should be connected to the main switch L1 connector, the blue wire of the power cord should be connected to the main switch N connector, and the yellow and green wire should be connected to the ground wire that protects the machine. For multiphase machines (400V 2N ~), instead of one brown wire, there is one black wire connector to the L1 connector and one brown wire connected to the L2 connector, the other connections remain the same.

EN

6

PROGRAMMING THE ELECTRONIC MACHINE PANEL

MAINTENANCE

All and any maintenance and repair must be performed byqualified personnel.

Equipment maintenance is essential to its proper functioning, it should be performed by qualified personnel, semi-annually, if not, it can lead to severe damage in the equipment.

Use only original components.

In case the power cord is damage, it should be replaced by FUTURETE, by the retailer or by similarly qualified personnel in order to avoid any hazard.

Cleaning and maintenance should not be carried out by children, unless supervised.

Cleaning:

Never use water jets while cleaning the equipment.

Other cleaning accessories can be used, which are not provided with the equipment, such as:

• Sponges;
• Cleaning cloths;
• Non-harmful chemicals, only and exclusively for cleaning.

This equipment is supposed to be used in ambient temperatures between 5 and 50°C, Horizon does not allow using it outside this temperature range.

The Horizon coffee machine can be used with coffee, milk and tea. The equipment should be cleaned daily so that the food used is not contaminated nor it causes contamination.

Daily:

Before switching off the machine after everyday use, you should clean the groups and replace the filters with the machine’s blind filter. This operation should be repeated once or twice per group.

The filter-holder guides should also be cleaned with a damp cloth, as well as the filters and filter-holder, using detergent specific for removing accumulated coffee oil. Clean the drip tray and grid.

Weekly:

Remove the cup holder grids and wash them adequately.
The device’s housing should be cleaned with a damp cloth,avoiding abrasive detergents and solvents, and never using water jets.

Descaling:

Only the manufacturer’s technical team can descale the equipment.

EXTRA INFORMATION

The Machine must be connected to a water source and water must be running to the machine before being plugged in to an electric source.

By plugging the equipment in without water, you will damage it.

If you are not sure how to install the machine we highly recommend you get a professional to set it up for you.

WE CREATE better EXPERIENCES!